fuel pump primes 17 times then stops, engine won't run
- Toilet Duck
- Posts: 516
- Joined: Wed Aug 22, 2012 10:54 am
- Location: Essex
- Contact:
fuel pump primes 17 times then stops, engine won't run
Evening knowledgeable people,
My Ariel Atom (2011 supercharged) has developed a weird issue. I was at a track day yesterday and all was well. Parked up in a pit garage and put some fuel in and then switched ignition on just to get a reading off the dash fuel gauge. The fuel pump normally primes and then cuts out after 3 seconds or so, but for some reason it kept priming. Having investigated a bit further today, it primes 17 times and then stops. It does it 17 times every time you put the ignition on and repeat. If you try and start the car whilst it is doing this fuel pump priming/cycling it will start but idle very rough. After the 17 cycles of priming the engine dies. The engine will not start at all after this (the fuel pump is not running)
Here is a video I took today whilst investigating:
There is a relay at the front of the car that clicks/energises when the fuel pump activates; I swapped that out today and it makes no difference. At the back of the car near the ECU there is this thing which also clicks every time the fuel pump runs/cycles:
Googling the part number at trackside yesterday reveals its a "fuel pump module relay" and is from (amongst other vehicles) a Freelander. I found a localish Freelander breakers/specialist and they took one off a vehicle they had there. I got them to connect up the module from my Atom. Although I didn't see them start the Freelander, they said it ran but didn't sound "right". I was hoping it would make the Freelander cycle the fuel pump like my Atom and confirm this was the faulty part but no joy. However, they kindly let me borrow the unit they took off their Freelander so I took it back to the track and fitted it, it didn't make any difference. Today I also resoldered all the pads on the printed circuit board inside my original fuel pump module relay and again no difference. I'm fairly confident it has eliminated this part from being the cause.
If I turn the ignition on without deactivating the immobiliser, both the relay at the front of the car and the fuel pump module relay click 17 times but the fuel pump does not run. I don't think the immobiliser is causing the issue.
There is a quick release connection on the fuel line feeding the fuel rail. I disconnected this and aimed it into a bucket. When the ignition is on and the fuel pump starts cycling/priming fuel pisses out.
I've googled to see if the Honda K20 engine has a fuel pressure sensor incase that is the problem but it doesn't appear to have one.
I don't know if there is a fuel pressure regulator (maybe that red thing visible in the video?) or if a faulty one could even cause this issue?
I am at a complete loss now. I hate electrickery faults on cars. Can anyone help or point me in the right direction?
Many thanks
My Ariel Atom (2011 supercharged) has developed a weird issue. I was at a track day yesterday and all was well. Parked up in a pit garage and put some fuel in and then switched ignition on just to get a reading off the dash fuel gauge. The fuel pump normally primes and then cuts out after 3 seconds or so, but for some reason it kept priming. Having investigated a bit further today, it primes 17 times and then stops. It does it 17 times every time you put the ignition on and repeat. If you try and start the car whilst it is doing this fuel pump priming/cycling it will start but idle very rough. After the 17 cycles of priming the engine dies. The engine will not start at all after this (the fuel pump is not running)
Here is a video I took today whilst investigating:
There is a relay at the front of the car that clicks/energises when the fuel pump activates; I swapped that out today and it makes no difference. At the back of the car near the ECU there is this thing which also clicks every time the fuel pump runs/cycles:
Googling the part number at trackside yesterday reveals its a "fuel pump module relay" and is from (amongst other vehicles) a Freelander. I found a localish Freelander breakers/specialist and they took one off a vehicle they had there. I got them to connect up the module from my Atom. Although I didn't see them start the Freelander, they said it ran but didn't sound "right". I was hoping it would make the Freelander cycle the fuel pump like my Atom and confirm this was the faulty part but no joy. However, they kindly let me borrow the unit they took off their Freelander so I took it back to the track and fitted it, it didn't make any difference. Today I also resoldered all the pads on the printed circuit board inside my original fuel pump module relay and again no difference. I'm fairly confident it has eliminated this part from being the cause.
If I turn the ignition on without deactivating the immobiliser, both the relay at the front of the car and the fuel pump module relay click 17 times but the fuel pump does not run. I don't think the immobiliser is causing the issue.
There is a quick release connection on the fuel line feeding the fuel rail. I disconnected this and aimed it into a bucket. When the ignition is on and the fuel pump starts cycling/priming fuel pisses out.
I've googled to see if the Honda K20 engine has a fuel pressure sensor incase that is the problem but it doesn't appear to have one.
I don't know if there is a fuel pressure regulator (maybe that red thing visible in the video?) or if a faulty one could even cause this issue?
I am at a complete loss now. I hate electrickery faults on cars. Can anyone help or point me in the right direction?
Many thanks
Re: fuel pump primes 17 times then stops, engine won't run
Sounds very wierd. Maybe attachments will help isolate
- Attachments
-
- MFRU Old Style (Small).jpg (48.61 KiB) Viewed 810 times
-
- Fuel Pump Relay Diagram_s.jpg (124.48 KiB) Viewed 810 times
-
- Connector 2_s.jpg (97.37 KiB) Viewed 810 times
-
- Connector 1_s.jpg (85.1 KiB) Viewed 810 times
- Toilet Duck
- Posts: 516
- Joined: Wed Aug 22, 2012 10:54 am
- Location: Essex
- Contact:
- Toilet Duck
- Posts: 516
- Joined: Wed Aug 22, 2012 10:54 am
- Location: Essex
- Contact:
Re: fuel pump primes 17 times then stops, engine won't run
smokin, do you (or anyone else) happen to have a fuse/relay diagram listing what does what on the Atom?
Cheers
Cheers
- Toilet Duck
- Posts: 516
- Joined: Wed Aug 22, 2012 10:54 am
- Location: Essex
- Contact:
Re: fuel pump primes 17 times then stops, engine won't run
Maybe the ECU is having an issue and rebooting/retrying 17 times before giving up. Do you have an OBD port? or an LED for check engine light? Might be worth checking to see if ECU is bitching about anything.
Re: fuel pump primes 17 times then stops, engine won't run
Also, the ECU just primes the pump for a set period of time rather than continuosly until pressure or some other signal is received
- Attachments
-
- Untitled.png (196.34 KiB) Viewed 796 times
- Toilet Duck
- Posts: 516
- Joined: Wed Aug 22, 2012 10:54 am
- Location: Essex
- Contact:
Re: fuel pump primes 17 times then stops, engine won't run
I only have a crappy £15 OBD blue tooth adapter, but I will give it a go. No other LED's etc
- Toilet Duck
- Posts: 516
- Joined: Wed Aug 22, 2012 10:54 am
- Location: Essex
- Contact:
Re: fuel pump primes 17 times then stops, engine won't run
I take it thats from your own kpro software? Is that freely available for diagnosis/checking ECU, or only available if you purchase an upgrade or get the ECU mapped etc?
Also, something I've just discovered, whilst the fuel pump is dancing on/off, when I press the throttle pedal you can hear it actuating the drive by wire butterfly in the throttle body. Once the fuel pump has primed 17 times and shuts down, the throttle pedal no longer operates the butterfly, it goes dead. I'm starting to think that this is an ECU issue....
Re: fuel pump primes 17 times then stops, engine won't run
Software is freely available but only of use if you have the kpro board in the ECU instead of the factory K100. Had CPL fit the board and TDi North send me the file from when they mapped my car.Toilet Duck wrote: ↑Wed Sep 19, 2018 7:51 pm I take it thats from your own kpro software? Is that freely available for diagnosis/checking ECU, or only available if you purchase an upgrade or get the ECU mapped etc?
I concur. If it's throwing a code then your £15 dongle plus an app like TorquePro should show itToilet Duck wrote: ↑Wed Sep 19, 2018 7:51 pm Also, something I've just discovered, whilst the fuel pump is dancing on/off, when I press the throttle pedal you can hear it actuating the drive by wire butterfly in the throttle body. Once the fuel pump has primed 17 times and shuts down, the throttle pedal no longer operates the butterfly, it goes dead. I'm starting to think that this is an ECU issue....
Re: fuel pump primes 17 times then stops, engine won't run
If OBD doesn't give any clues and if you haven't already tried, might be worth powering off/on the ECU. Using master cut-off if you have one or disconnecting earth strap from battery, leave it off for 10 mins or so, reconnect and try it.
- Toilet Duck
- Posts: 516
- Joined: Wed Aug 22, 2012 10:54 am
- Location: Essex
- Contact:
Re: fuel pump primes 17 times then stops, engine won't run
Just tried two blue tooth dongles and TorquePro on my tablet and unfortunately the tablet can't connect to the blue tooth reader. I've previously used this set up on numerous everday type cars and it's always worked, so I don't know if the Atom uses some unique protocol or if my set up just isn't compatible.
Cheers
Ironically my Atom is booked into CPL in a couple of months for some major work, including a FlashPro. I think I have exhausted my DIY skills so I think I'll get in touch with them as they are Hondata experts and try and get this looked at beforehand. My suspicions is that this is an ECU related problem.
Cheers
Re: fuel pump primes 17 times then stops, engine won't run
I didn't have any problem with my obd setup, it works the same on the Atom as other cars I've hooked up to. I suspect it's a symptom of the fault. My dongle has lights so you can see it's connected sucessfully to the ECU, do yours?Toilet Duck wrote: ↑Thu Sep 20, 2018 3:10 pm ... so I don't know if the Atom uses some unique protocol or if my set up just isn't compatible.
CPL will have ECUs will full diags to swap in to narrow down the problem. Experts in Hondata with plenty of Atom experience, probably better placed to sort your problem than the factory in this instance.Toilet Duck wrote: ↑Thu Sep 20, 2018 3:10 pm Ironically my Atom is booked into CPL in a couple of months for some major work, including a FlashPro. I think I have exhausted my DIY skills so I think I'll get in touch with them as they are Hondata experts and try and get this looked at beforehand. My suspicions is that this is an ECU related problem.
- Toilet Duck
- Posts: 516
- Joined: Wed Aug 22, 2012 10:54 am
- Location: Essex
- Contact:
Re: fuel pump primes 17 times then stops, engine won't run
That make/model supports all OBD II protocols so no green light suggests ECU isn't able to establish comms. I suspect the ECU is rebooting every few seconds (given the almost continuous attempts to prime the pump) and so is not getting far enough in its startup procedure to do comms. Could be something as simple as a bad ECU ground or, sadly, could be a knackered ECU. Please let me know what CPL discover
Who is online
Users browsing this forum: No registered users and 1 guest