As per title, anyone ever had an atom on a 2 post? I allready have very long arms on it. I would think rear underneath the engine and front on the tube from wheel to chassis, close to the mounting point at the chassis side?
Or will the wheels be in its way?
Atom (4) on a 2 post lift? Possible or not?
- speedmachine
- Posts: 1247
- Joined: Tue Jun 19, 2012 10:20 am
- Location: Netherlands
- Contact:
Re: Atom (4) on a 2 post lift? Possible or not?
Hi Speedmachine,
Mine works just fine, front as you suggest and the rear on the chassis joint (not engine) where the little bracing piece is. This just misses the intercooler/fuel tank.What sort have you got, or are getting?
Merry Christmas, Aidan
Mine works just fine, front as you suggest and the rear on the chassis joint (not engine) where the little bracing piece is. This just misses the intercooler/fuel tank.What sort have you got, or are getting?
Merry Christmas, Aidan
- speedmachine
- Posts: 1247
- Joined: Tue Jun 19, 2012 10:20 am
- Location: Netherlands
- Contact:
Re: Atom (4) on a 2 post lift? Possible or not?
This is my lift:
https://www.twinbusch.nl/product_info.p ... cts_id=249
I have an atom 4 incoming, so couldnt try myself, but wanted to make sure it works
Re: Atom (4) on a 2 post lift? Possible or not?
Attached is mine. I can't see any reason yours won't work. If no-one on here has experience of yours then by all means PM me and I can take some measurements of the pick-up/jack points.
Good luck, Aidan
- speedmachine
- Posts: 1247
- Joined: Tue Jun 19, 2012 10:20 am
- Location: Netherlands
- Contact:
Re: Atom (4) on a 2 post lift? Possible or not?
Thanks for this, I’m pretty sure it works if yours works, perfect stuff
Who is online
Users browsing this forum: No registered users and 2 guests