inner tie rod end specs?
inner tie rod end specs?
Anyone know what the inner tie rod end specs are on the Atom 3? I'm based in the US, but i assume UK Atoms use the same setup. My tie rod ends have some slop so need to replace and want to make sure I'm ordering the correct ones.
- John Scherrer
- Global Moderator
- Posts: 5124
- Joined: Sat Mar 07, 2009 1:20 pm
- Location: Willington, Bedford UK
- Contact:
Re: inner tie rod end specs?
Might be best to speak to TMI in the US to confirm the spec.
The early Brammo built US cars were a different spec I believe, but you have an Atom 3 so it’s probably a TMI built car.
In the UK, the rod ends used are produced by Aurora.
There are 2 specs - standard and race spec.
They are available from the UK factory as are the bearings at the ends of the actual shock absorbers.
Other web sites sell them too ..
This earlier thread may help :-
viewtopic.php?f=81&t=15290&hilit=Aurora
This is one of the sites that list the standard and race spec parts:
https://www.skunkwurx.co/catalogsearch/ ... +end+Ariel
The early Brammo built US cars were a different spec I believe, but you have an Atom 3 so it’s probably a TMI built car.
In the UK, the rod ends used are produced by Aurora.
There are 2 specs - standard and race spec.
They are available from the UK factory as are the bearings at the ends of the actual shock absorbers.
Other web sites sell them too ..
This earlier thread may help :-
viewtopic.php?f=81&t=15290&hilit=Aurora
This is one of the sites that list the standard and race spec parts:
https://www.skunkwurx.co/catalogsearch/ ... +end+Ariel
Atom 3 310 Supercharged (2011), Now Sold
Re: inner tie rod end specs?
Thanks John, yes, mine is a TMI built one. I have an email out to them as well, but they often won't provide exact specs vs just selling them.
Who is online
Users browsing this forum: No registered users and 15 guests