by K20A2 » Wed Dec 30, 2020 5:14 pm
Just to share the result...
I received information from Ariel, that 3/8 x 24UNF is fine and the total length below the nut is 19mm.
I measured the thread of the original bleed nipples sticking out of the calliper and it was 3mm+.
So I ordered the ones with the 16mm total length as linked above.
Although the assembly worked for the rear callipers (have not replaced the fronts so far) it is very close to not being enough with 16mm.
Unfortunately about 17mm is not available and the next length would be 22mm and to be on the very safe side I would probably go for these next time.
Replacing the brake fluid and bleeding is very easy now.
Just to share the result...
I received information from Ariel, that 3/8 x 24UNF is fine and the total length below the nut is 19mm.
I measured the thread of the original bleed nipples sticking out of the calliper and it was 3mm+.
So I ordered the ones with the 16mm total length as linked above.
Although the assembly worked for the rear callipers (have not replaced the fronts so far) it is very close to not being enough with 16mm.
Unfortunately about 17mm is not available and the next length would be 22mm and to be on the very safe side I would probably go for these next time.
Replacing the brake fluid and bleeding is very easy now.